Oberflex offers the widest range of wood laminates in the world. Boasting more than 60 species of wood available in almost 600 products, its range of panels, of the highest quality in both aesthetic and technical terms, now sets the standard in all fields of interior architecture, decoration and industry.
This recognition places the seal on a century of expertise in the decorative wood sector, supported by a veritable culture of innovation, in aesthetic and technological terms, and a stringent approach to quality management throughout the production process.
Panel composed of solid woodstrips, boat decking style, intended for bathroom floors and walls, showers. swimming pools, dressing rooms and bedrooms.
DECK D’OBER panels begin with a strip of wood and end with another strip of wood.
Deck d’Ober planels manfactured with 41 mm width solid wood strips can be used for curved surfaces: rounded bathtub surrounds, cladding of columns..(bending radius: 400mm)
For outside applications or in very humid environment, we only recommend the use of Teak wood.
The panels should be fabricated in compliance with Specification NF XP B 54-202: << decorative wood panels – specifications (Decorative, wood-veneered panels – Specification) or equivalent.
On-site fabrication conditions
Fabrication should be normally take place in the following conditions:
- Prior to installation, the panels must be stabilized to ambient conditions.
- To this effect, store them for at least 3 days in a flat position in the place where they are eventually to be installed.
- When installling the panels, allow for a 1 mm/m expansion point.
- Increase that joint to 1.5 mm/m in the following cases: for rooms likely to be subjected to major atmospheric
humidity variations
in cases where flame-retardent (M1-rated) panels are used.
On-site conditions
The rooms where the panels are to be installed should be normally conform to the following conditions :
- they should be roofed
they must have been heated or air-conditioned for at least 24 hours
all cement and plasterworks should be dry. - ambient temperature must not fall to below 15° C
ambient air humidity during the stabilization process and at the time of installation should respond to the following criteria. - If the panels are installed in a dry area: The relative air humidity during the stabilization phase should be within the range of 40 to 60%, Once the panels are installed, the ambient air humidity may exceed 65% only for a couple of weeks per annum.
If the panels are installed in humid area (bonded to hydrophobic substrate):
The relative air humidity during the stabilization phase may exceed the range 40% to 60%
Once the panels are installed, the ambient air humidity may exceed 85% only for a couple of weeks per annum